top of page

What SEER2 Rating Does a New AC Need in Pennsylvania?

Nov 9
5 min read

A new split-system central air conditioner sold for a Pennsylvania home needs a rating of at least 13.4 SEER2. That is the federal minimum for split-system air conditioners manufactured on or after January 1, 2023, under the Department of Energy standards in 10 CFR 430.32. Pennsylvania is not one of the states listed in the stricter Southeast or Southwest regions, so the base national standard applies. Trane describes 13.4 SEER2 as equivalent to 14 SEER under the old rating system.

 

The number trips people up because a different minimum shows up in search results. In a September 2026 Google search, one HVAC contractor's page stated that new air conditioners in Pennsylvania need 14.3 SEER2. The federal regulation says otherwise: 14.3 SEER2 is the minimum for split-system heat pumps nationwide, and a Southeast and Southwest figure for smaller split air conditioners, not the requirement for a central AC in Pennsylvania. This post explains what SEER2 means, the minimums that apply here, how SEER2 compares with the older ratings, and what else to check when you are comparing quotes.


All Pro Plumbing - Blog Image

What Is SEER2?

 

SEER2 stands for Seasonal Energy Efficiency Ratio 2. Trane defines SEER as the total heat removed during the cooling season divided by the total electricity used. A higher number means more cooling for each unit of electricity.

 

SEER2 replaced SEER as the required rating on January 1, 2023. The difference is the test. According to Trane and the Air-Conditioning, Heating, and Refrigeration Institute (AHRI), the new Appendix M1 test procedure increases the external static pressure used in testing by up to five times, from 0.1 to 0.5 inches of water column, which AHRI says reflects field conditions more accurately.

 

What Are the Minimum Efficiency Ratings in Pennsylvania?

 

Under 10 CFR 430.32(c)(5), equipment manufactured on or after January 1, 2023 must meet these minimums:

 

  • Split system air conditioners: 13.4 SEER2, both under and over 45,000 Btu per hour

  • Split system heat pumps: 14.3 SEER2 and 7.5 HSPF2

  • Single-package air conditioners: 13.4 SEER2

  • Single-package heat pumps: 13.4 SEER2 and 6.7 HSPF2

 

HSPF2 measures heating efficiency for heat pumps. The regulation's section (c)(6) adds stricter air conditioner requirements for the Southeast and Southwest regions, and Pennsylvania is not listed in either one, as the next section shows.

 

If you are considering a heat pump instead of a central AC, our guide on what a heat pump is and whether it is right for your home covers how they work.

 

Which States Have Stricter AC Standards?

 

The regulation's section (c)(6) sets higher minimums for split-system air conditioners in two regions:

 

  • Southeast: Alabama, Arkansas, Delaware, Florida, Georgia, Hawaii, Kentucky, Louisiana, Maryland, Mississippi, North Carolina, Oklahoma, South Carolina, Tennessee, Texas, Virginia, the District of Columbia, Puerto Rico, and U.S. territories

  • Southwest: Arizona, California, Nevada, and New Mexico

 

In those regions, split-system air conditioners under 45,000 Btu per hour need 14.3 SEER2, and Trane lists 13.8 SEER2 for larger split systems. The Southwest also carries EER2 requirements. Compliance in those regions is tied to the installation date, for systems installed on or after January 1, 2023.

 

Pennsylvania borders two of those Southeast states, Maryland and Delaware, so it helps to check which region a source is describing before trusting its number. A home in Bethel Park falls under the national standard, where the base requirements are tied to the date the equipment was manufactured.

 

How Does SEER2 Compare to the Old SEER Rating?

 

Because the test changed, the same equipment gets a lower number under SEER2. Trane gives these equivalents:

 

  • North, all air conditioners: 13.4 SEER2, equivalent to 14 SEER

  • Southeast and Southwest split air conditioners: 13.8 to 14.3 SEER2, equivalent to 14.5 to 15 SEER

 

That means a quote listing 13.4 SEER2 is not a step backward from an older 14 SEER system. It is the same efficiency level, measured with a tougher test.

 

Does the SEER2 Rule Mean You Have to Replace Your AC?

 

No. The federal standards apply to equipment manufactured on or after January 1, 2023. Trane describes the standards as applying to newly purchased equipment and does not say existing systems must be replaced.

 

The rules matter when your current system fails, and you are shopping for a new one. Duquesne Light's Instant Discounts program site lists equipment that is unreliable, inefficient, or more than 15 years old as a sign it is time to consider an upgrade. Our HVAC repair vs replacement guide walks through that decision.

 

Does the Refrigerant Change Affect a New AC?

 

It can. The National Association of Home Builders reports that the EPA issued a final rule on May 26, 2026, allowing continued installation of R-410A systems manufactured or imported before January 1, 2025, until supplies run out. The previous cutoff for installing those systems had been January 1, 2026.

 

NAHB explains that newer systems use A2L refrigerants, which have a lower global warming potential, and that R-410A production is being cut to 15 percent by 2036. When you get quotes, ask which refrigerant each system uses.

 

What Should You Check on an AC Quote?

 

The SEER2 minimum is a floor, not a recommendation. Trane says a good SEER2 rating depends on what you want from a cooling system, and higher efficiency units come with a higher upfront cost in exchange for long-term savings on energy bills.

 

Items to confirm on each quote:

 

  1. SEER2 rating of the matched indoor and outdoor equipment

  2. EER2 rating, which Trane says measures efficiency at a 95°F outdoor temperature, during peak cooling demand

  3. Refrigerant type, R-410A or an A2L refrigerant

  4. Utility discounts, such as Duquesne Light's Instant Discounts on air conditioners through participating distributors, if you are in its service territory

  5. Installation scope, including what happens to the old equipment

 

For pricing factors, our guide on how much AC installation costs in the South Hills covers what drives the total. If your current system is struggling but not dead, see what Pittsburgh homeowners should know about AC repair.

 

FAQ

 

What is the minimum SEER2 rating in Pennsylvania?

 

13.4 SEER2 for split-system and single-package central air conditioners manufactured on or after January 1, 2023.

 

Is 14.3 SEER2 required for air conditioners in Pennsylvania?

 

No. Under 10 CFR 430.32, 14.3 SEER2 is the minimum for split-system heat pumps. Split-system air conditioners in Pennsylvania need 13.4 SEER2.

 

What does 13.4 SEER2 equal in SEER?

 

Trane says 13.4 SEER2 is equivalent to 14 SEER.

 

What is the minimum HSPF2 for a heat pump?

 

7.5 HSPF2 for split-system heat pumps and 6.7 HSPF2 for single-package heat pumps.

 

Do I have to replace my old AC because of SEER2?

 

No. The standards apply to new equipment manufactured on or after January 1, 2023, and Trane describes them as applying to newly purchased systems. A working system can stay in place.

 

Can contractors still install R-410A air conditioners?

 

NAHB reports that an EPA final rule from May 26, 2026, allows R-410A systems manufactured or imported before January 1, 2025, to be installed until supplies are depleted.

 

Air Conditioning Installation and Repair in Bethel Park

 

All Pro Plumbing Heating & Cooling handles air conditioning repair, maintenance, and installation for homes across Bethel Park, the South Hills, and Allegheny and Washington counties. The company gives upfront, per-job pricing before any work begins, and same-day service is available. Registered Master Plumber John Oakes founded All Pro as a home-based family business in 2006, and it now runs from its own office on Library Road with 10 local employees. See air conditioning repair and installation and HVAC services.

 

Visit All Pro Plumbing or call 412-595-8204 today. Contact us for more information.


All Pro Plumbing - Main Logo

 
 
 

Comments


What Our Customers 
Are Saying

Real reviews. Real results.

“Had a great experience with All Pro when my A/C stopped working. Everyone was incredibly friendly and professional. They went over and above to ensure that the job was completed successfully. I would confidently recommend them to anyone”

– Andrea Ward

“We had a leak behind our drywall.
All Pro found the leak, fixed it and made sure everything was working properly. If you are looking for a plumber call ALL PRO.  You'll thank me later!”

– Sandy Raimondi

“Was a pleasure dealing with a company that actually returns phone calls... and did a terrific job!”

– Jack C.

Plumbing & HVAC Tips for Bethel Park Homeowners

Real plumbing and HVAC advice for homeowners across Bethel Park and the South Hills, straight from the licensed team at All Pro Plumbing. Learn how to catch problems early, keep your systems running, and know exactly when to call for help, day or night.

All Pro Plumbing Plunger.png
bottom of page